How To Install Drip Edge On Hip Roof

Space the fasteners by about 12 inches.

How to install drip edge on hip roof.

Make sure the corner is tight and that the bottom edge is tight to the fascia before nailing off the drip edge. Place a nail at one end then the other. If the gutter is lower than the bottom edge of the drip edge install flashing behind the drip edge and over the back edge of the gutter to remove the gap. Make sure the outer edge extends over the gutter.

If the overlap is too short fix it by placing drip edge under the first row of roof shingles and be sure that the exterior edge is reaching over the gutter. Install the drip edge by fitting it on the roof eave pushing it tightly against the edge of the plywood and nailing or screwing it down. Learn more about drip edge at. How to install a drip edge.

Use 1 inch galvanized roofing nails or 3 4 inch exterior screws. Apply a continuous bead of cement along the top of the drip edge then press down on the shingle. Overlap two pieces of flashing that meet end to end by at least 1 inch. The drip edge should extend at least 2 inches on the roof.

Slip the wide flat flange of the material all the way under the first course of roof shingles as illustrated. Slide the corner tight to the fascia. If it doesn t pull the drip edge out slightly from under the shingles. Gaf mastering the roof chapter 05 the drip edge is critical to provide a finished look and to add waterproofing.

Must be installed at the rakes and eaves of the roof. The vertical leg of the drip edge should be at least 1 5 inches wide and extend at least 0 25 inches below the sheathing.