Continuous flashing against a sidewall is one way to install a roof but it s not the correct way.
How to install flashing on a shingle roof.
Use the metal break tool to bend the flashing lengthwise in the middle according to the angle of the roof joint.
Most flashing is 8 inches wide.
Hammer one nail to the.
Protect the eave from ice dams and sideways rain step one in steep slope roofing is the edge flashing.
Align the step flashing with the leading edge of the starter course and nail it in place using one nail in the upper corner.
One common method is to lay the edge metal under the eaves membrane and over the rake.
How to install roof flashing against a wall.
Install new flashing metal.
Even if one piece of step flashing fails the flashing and shingle below it start the process over again.
Ensure it sits flat and extends at least 8 inches above the shingles.
Then set the piece down.
Using your staple gun secure the felt to the roof.
Use roofing nails to install the l shaped flashing flush with the roof and wall then cover it with roofing cement and reattach the roofer s felt.
Step 6 make a 10 degree bend on the shingle edge of the flashing approximately 1 2 inch from the edge.
4 inches should go up the house wall and 4 inches should go on top of the porch roof shingles.
Begin by removing the shingles at the affected area and removing old flashing if present.
Step flashing step flashing redirects the water back onto the shingle.
Install the step flashing before running the first row of shingles install a piece of step flashing along the sidewall so that it sits tightly against the roof.
Nail it in place with two nails one.
If you live in an area with inclement weather you should consider using a special ice and water protector.
Use sticky back ice and water shield as underlayment where ice dams or leaf and twig dams are likely to build up and at.
Then nail the new l shaped flashing under the builder s felt but above the fascia board.
Details concrete masonry roofing wrb flashing.
Bend it back so that it overlaps the corner flashing.
How to install step flashing with a wall corner step three.
Overlap each row at least 3 to 4 inches.
