Measure the length and width of your deck to attach the ledger correctly.
How to cut siding for ledger board.
Use a nail as a temporary place holder to check the ledger to see if it s leveled.
Then subtract that amount from the length of the piece of siding you re going to cut.
Step 3 add 2 x 8 planks between joists.
For your safety be careful not to saw through nails.
For example if the section of wall you re covering is 5 feet 1 5 m long and the piece of siding is 9 step 2 mark the line you want to cut on the siding with a pencil.
Nail undersill trim j channel will also work over the bottom cut using 11 gauge aluminum nails.
Once you have drawn the outline of your ledger board on the stucco you can cut through the stucco and the metal screed it uses to grip to the house.
Measure the length of the section of wall you re covering with siding.
Step 1 use measuring tape to measure how much siding you need to cut off.
The total you get is how much you ll need to cut off the siding.
Once the connection is made make sure you flash the cladding above below and to both sides of the opening.
Locate the rim joist and mark an outline on the siding where you want to position the ledger board using a tape measure pencil and chalk line.
Overlap flashing by 3 inches and cut it for the doorway.
Then cut away the siding.
Start by making an outline on the siding where you want to position the ledger board.
How to attach a ledger board to a vinyl sided house.
Be careful not to cut too deep and concentrate on cutting a straight clean line.
First ensure your circular saw is equal to the thickness of the deck then cut the ledger outline.
Start by using plunge cuts across the top and bottom of the horizontal length of the ledger board followed by the shorter vertical cuts for the ends using a cold chisel.
Make the outline large enough to include space for the deck boards on top the ledger and any trim boards on the sides.
Cut away the marked area of siding with tin snips.
Step 2 cut away the vinyl siding carefully cut away the siding with a utility knife braced along the edge of the carpenter s square to avoid slicing through the house wrap.
You will then have to use a claw hammer or a pry bar to remove the nails.
Slide the flashing underneath the siding 1 inch.
Cut siding and flash.
