How To Hang Lights On Awning

Then add each of the individual measurements together.

How to hang lights on awning.

Install the bulbs and check your lights. To begin your install clean the area under your awning rail with an alcohol wipe and let it dry. There are specific instructions on how to hang the lights on the rv awning and again it is according to the manufacturer instructions. To get your strip lights evening placed measure down your desired amount from the bottom of the awning.

Make a mark at either end then draw a line between these two marks. Round up the number you get to the nearest 1 2 ft 0 15 m and write it down on a pad of paper. Run your adhesive along the area beneath the awning and firmly press your light strip onto it. To reinforce the stickiness you can use outdoor mounting tape or for a more permanent bond you can even try a silicone glue.

Continue this process adding staples near each light. How to hang lights on rv awning. To install them install a rubber hook at both ends of the awning rail and hang the lights there. Most of the awning lights come with a mounting channel as well as installation instruction.

Hanging lights are easier to install than strip lights. So cut your light strip and adhesive tape about 2 inches shorter than the total length of your awning. Climb a ladder and stretch a tape measure along each section of the overhanging structure where you plan on hanging lights. Starting with the string light closest to your power supply use a staple gun to fasten the lights under your railing.

Pull the string of lights taut as you go. If you want something a bit more durable then you can buy sticky clamps instead of the hooks.