The alternative is to cut it into small size using a circular saw.
How to cut a plywood sheet without a table saw.
It turns out you can.
How do you cut plywood without a table saw.
You can buy or make clamp on jigs that allow you to make long cuts in a straight line with a circular saw or jig saw.
Another trick is to tape the both sides of the cutting line with masking tape and then cut through the tape.
This puts the plywood at a convenient height and the saw blade will nick the edges of the beams rather than cut a slot across the flat surfaces.
It also works well as a way to accurately cut plywood if you don t have a table saw.
Finish off the cut carefully in this position.
Another great tip on how to cut plywood without chipping and make a smooth cut hold your plywood steady and keep it pressed steadily against the fence which is the straight edge of your saw.
Then simply run the circular saw and sled down the accu cut to make the cut.
As the end of the cut approaches get your two hands on two sides of the blade.
The large size and the weight of plywood also makes it difficult to cut a full sheet directly on the table saw.
This lets you do many things people normally do on a table saw such as cutting the rounded edges off 1 4 or 2 4 lumber or ripping plywood.
I set my shop boxes to a lower height and turned the i beams 90 degrees.
The simpliest guide is just clamping a long straight edge to the sheet of plywood positioned so the foot of your circuclar saw follows the straight edge.
Press the sheet forward using your closest hand to the blade.
When i need a perfect cut with a circular saw i use a guide.
Use your hands to direct the plywood through the blade.
Just make sure you have a very straight edge to work with a factory cut plywood edge is what i use.
The size makes it difficult to keep the sheet flat on the table or bench and.
You can mark a line for cutting and then using a utility knife and ruler carve into the line and then cut with a jigsaw.
By our experience using a proper blade with a masking tape provides perfect results.
The rubber grips on the bottom of the accu cut guide should hold it in place while you make your cut.
Plywood usually come in 4 x 8 sheets which is a very unwieldy thing to cut with any tool.
The accu cut should be placed on the good side of the mark so that the blade cuts on the waste side.
