How To Apply Vinyl Wrap Interior

Once you have a starting peel back the liner and place the vinyl wrap onto the target surface.

How to apply vinyl wrap interior.

Pull the vinyl taut against the edge with a good amount of force to keep it as smooth as possible. Apply the heat gun evenly across the vinyl which will draw it to the surface of the vehicle. How to vinyl wrap dash trim of a car or truck. To wrap around contours heat the vinyl a little until it is soft then work it around with a plastic card making sure to clear any air bubbles that you get and avoid any wrinkles.

Component you re working with. Step 2 clean up wash down the surface of the area you want to wrap with soap and water making sure that any dirt and grime is completely removed. Once you have reached the edge of the trim you can trim the vinyl down to size leaving about a quarter inch to wrap around the back side. I ve showed you guys how to paint your interior trim pieces before but now this i ll show you how to do it in a less permanent manner.

The 1 metre packs are ideal for interior and exterior trim but if you want to wrap a roof you ll need the larger one. Once the vehicle panel has been wrapped and tucked it s time to apply the heat and set it in place for good. Soften the film with a heat gun while pulling down on it to remove wrinkles. Change the colour an.

Make sure your material is larger than needed for easier handling. Heat the vinyl with a heat gun before wrapping the edges. Heat the wrap and set. Restyle your car truck or suv with our custom dash kits window tint and caliper covers.

Tune your ride with headlight and taillight tint covers. Shop through our wide variety of interior and exterior accessories. Using moderate pessure on your squeegee apply the film while pushing out trapped air from beneath starting from the middle outward. Shield it from road rash with paint protection kits and wheel bands.

In this vid we are wrapping a 2015 mustang interior dash piece that has a lot of different areas and contours. Then stretch it under the edge while holding it taut.