Genie Garage Door Will Not Open All The Way

This could be the result of a faulty capacitor.

Genie garage door will not open all the way.

T his is a pretty uncommon problem but one that can happen after you ve first installed your garage door opener. To check the balance pull the emergency release cord or chain to disconnect the door. Press and hold the wall console button until the garage door is completey closed. If you re genie excelerator just stops when either trying to open or close your garage door check out this video.

If your garage door is not balanced right it won t go up or down all the way. Door starts down then stops before it is closed. Check garage door for binding. This issue can be an easy fix.

You should now be able to move the door up and down by hand. When your garage door won t open all the way it can seem like the end of the world. They both have lights and both lights should be on. If the problem persists check to see if the red safe t beam led indicator is blinking.

A test will reveal whether or not it needs to be replaced but the test involves discharging the capacitor which can be dangerous. When your garage door won t open with the remote there are few things that can cause this problem. Check for and clear any obstructions in its way. It s important to get this switch at just the right distance from the motor so that the door is able to close all the way but the motor also knows to stop running.

Make sure it is hanging down from the motor. From here lift the garage door by hand about 3 feet above the ground and then release the door and see were it lands. This is related to the up limit switch. If the door goes up but you can t make it go down you probably need to adjust the sensors.

You might be out of range. There is one on each side of the door. Your garage door has two simple jobs. The antenna on the motor could be damaged or blocked from the signal.

Check for interference from adjacent photo eye sensors of any brand. If one or both of these sensors are not receiving power or are not emitting the signal properly your garage door will respond by failing to close all the way. If it is be sure that the lenses are mounted five to six inches from the floor on either side of the garage door opening. If an operational problem exists and the garage door opener will not close the opener can be forced to close.

This is a safety feature but it can be annoying when there isn t anything actually blocking the door. If the motor. Try making small adjustments.