Genie Garage Door Will Not Close Unless Hold Button

Try using your remote to open or close your door to determine if the reprogramming was successful.

Genie garage door will not close unless hold button.

After i hold the button down to close it the sensor lights come back on. Door starts down then stops before it is closed. Hold down on the buttons until the in car red light flashes rapidly. Check for interference from adjacent photo eye sensors of any brand.

Garage door does not close. When the door is up the sensor lights are off. Hold your transmitter up near the selected button pressing both the garage door remote and the selected in car transmitter button simultaneously. But seems to be unable to close all the.

To open my garage door i have to hold down the button on my wall until the door is at least halfway up. Then within 30 seconds hold the button on your remote for three seconds or until garage door opener s lights flash or the led light on your opener blinks. This sets the in car transmitter to be your garage door openers make transmitter but you are not done. My garage door will not close unless i hold the button down.

The problem starts when you hit the button to close it and the door starts to close. It just opens an inch and stops. If i lift my finger off the button before that point the door will stop and then i have to press the button again and the door will go back down. My wife had just come home.

The garage door did not want to close when she pressed the button on the remote. When i push the remote in my vehicle to close the garage door it will close and remain closed for. It was late in the evening. Eye on both side of the door is not on i have to hold down the bottom in the garage to bring the door down.

My tools are in the garage. I ve made sure there are no obstacles and that the sensors are aligned properly. The remote control in my car will not work at all. Check garage door for binding.

It had worked just fine a few hours earlier. If an operational problem exists and the garage door opener will not close the opener can be forced to close. I have a genie intellicode.