Genie Garage Door Opener Not Responding To Remote Antenna Extension

The method to reengage the carriage depends on the model of garage door opener you own.

Genie garage door opener not responding to remote antenna extension.

If the remote works from inside the garage but not from the outside then most likely the antenna wire on the garage door opener itself may be damaged broken or not in visible range. Try using your remote to open or close your door to determine if the reprogramming was successful. Improve the performance of an opener and increase the range by adding an antenna extension that you can buy online or at electronics outlets. See your owner s manual for more details.

Check that the emergency release cord has not been pulled. Your garage door may be disconnected from the opener. Then within 30 seconds hold the button on your remote for three seconds or until garage door opener s lights flash or the led light on your opener blinks. If this is the reason you will need to reengage the carriage.

Replace the genie remote if needed. Check to be sure the antenna is attached and if it is not hanging down from the unit move the antenna so it can catch the beam being sent by the remote. Check all remotes if all the remotes and wireless devices stopped working at the same time this could indicate the circuit board needs replaced replace the remote battery if neccesary. Reprogram the remote to the power head.