Replacement is an easy diy repair.
Gas wall heater pilot light blowing out.
Blow into the hole through a straw if you do not have an air compressor.
A bad thermocouple will shut off gas to both the pilot and the.
It s the soul of your water heater.
However the problem is no longer being able to light the pilot but keeping it lit.
These types of heat appliances utilize pilot lights to light the main burner.
Not enough combustible air.
This can happen on excessively windy days or nights.
The pilot going out is a common occurrence for those that have water heaters or older gas furnaces.
A leak in the output duct of the furnace could cause air to blow into the area.
Gas heaters whether they warm up air or water in a home rely on a pilot light to trigger the flame of the actual heater.
If your water heater is located in a utility closet or anywhere it is starved for combustible air the pilot light may go out.
If your pilot light re lights easily after going out overnight it s possible it was blown out by a draft.
Gas heater pilot light troubleshooting.
5 improper air flow or a strong draft blows the pilot out.
Clean the pilot assembly if the flame has a yellow tip which means dirt and dust or when the flame goes out after the pilot lights.
It seems that whenever we have high winds the pilot light goes out and of course it ususally happens overnight.
If the gas is lit it fully opens the main valve to provide a steady supply of gas.
If you re water heater doesn t have a sealed combustion chamber it s possibly that the pilot light can be blown out due to a strong draft near your unit.
Is there anything that can be done to prevent the wind from coming down through the spout and blowing it out.
That can turn into a nuisance for both maintaining heat or hot water.
Gas wall heaters whether vented or unvented can supply enough heat to warm a small or medium sized room and they can operate with propane or natural gas.
If your hot water heater suddenly stops working chances are a bad thermocouple has shut off the gas to the pilot light.
There is a class action against them.
Use an air compressor to blow air into the air inlet hole a small hole two inches from where you see the pilot flame come out.
If this pilot light ever goes out.
A thermocouple senses the heat of the pilot and allows gas to flow to the burner.
