Garage Door Won T Go Down Light Blinks

The problem is either due to a blocked path between the sensors dirty eyes loose wires at the sensors or at the motor head or just bad sensors.

Garage door won t go down light blinks.

If you own a new garage door opener that comes with a locking feature it s possible someone may have accidentally locked your garage door by pressing the lock button. Troubleshooting a liftmaster with a flashing light step 1. The blink rate on the garage door opener service light points to various error codes. If this is your situation the first thing you ll want to do is make sure these sensors are properly lined up.

Then open and close the door. Garage door opener light blinks led light blinking indicates a problem note. The led light that is referred to in this article is the small light that is located on the opener near the adjustment learn or program buttons. Count the number of times the led light beside the learn button flashes before it pauses and begins blinking.

Ten flashes of the light tells you there is a problem with the door safety sensor circuit. If one or both leds is blinking the sensors are misaligned. To check for resistance start with the door closed and pull the red handle. The movement should be fluid with no tough spots.

Place a step ladder under the liftmaster motor so you can comfortably access the learn programming button. You will need to use a ladder to access this area. If your garage door sending sensor is showing a yellow light and the other does not show a green light it is likely they are misaligned. There are several reasons why your garage door opener is doing this.

If any of these sensors should happen to get bumped or misaligned the infra red beam would be thrown off and the garage door won t go down. If you try to open your door using a remote while the lock system is engaged you ll notice that the garage door light will begin blinking continuously. Having your garage door light blink continuously is not only annoying it s also a sign that there is something wrong with the mechanism. The transmitters remotes will not work to close the garage door.

Look at the led s on both door sensors. If the led s on both sensors are off the problem is in the logic board or the sensor wiring. When the infra red sensors are malfunctioning usually one of the sensor lights will be blinking. You may want to check the back of the motor unit.

However the two most common reasons include a problem with the lock button and malfunctioning safety reversing sensors.