When adjusting your garage door cables keep in mind that if you loosen the shaft too much the cable can unwind and become tangled.
Garage door wires tangled.
Cables are unwound from the drum also known as a spun cable loose cables can occur if a garage door hits something when it comes down.
Call a professional right away.
For whatever reason the garage door won t open and or close.
These cables can become frayed and worm requiring replacement.
This work should be done by a qualified garage door contractor.
Unevenly hanging door the line of the bottom of the door is at an angle cables on one side of the door are loose.
The cables are the parts that do the work of lifting the door and releasing it when it is closed.
In this scenario the cables are located inside the springs which run vertically along the left and right sides of the garage door.
The wire that is spooled on either side of the door to lift and release the door hits a snag when lowering the door then automatically reopens.
Lift cables are found in garage doors with torsion springs.
Clip the cable in the track if the door is unable to move.
2 secure a vise grips just below the bottom of the door on the track to prevent the garage door from dropping during.
Open the garage door.
It s also important to remember that when you go to tighten the shaft only tighten until all the slack is gone from the cable.
Too much tightening or loosening can cause problems.
The issue is going to be due to the cable untangling and lodging on the road and drum.
In this configuration the cables are attached to the bottom corners of the door and routed to the torsion springs located above the door.
How can i untangle the wires.
Retaining cables are found in garage doors with extension springs.
Garage door won t close spool wire is tangled.