Push the door back to adjust the door and get the center aligned again.
Garage door tracks to one side.
Thanks for the quick response.
You will notice that there is one garage door track on each side of the doorway.
Adjust the spring tension on each side of the door until it does.
This can happen if your garage door receives an.
It s not uncommon for these tracks to wind up out of alignment.
Changed them to be the same and now the cables are equal and the track isn t hitting the door.
If you ve had your door for a while or are in and out of it a lot it can easily end up out of alignment.
Maintenance of an out of balance garage door.
It is possible that the vertical track down the side has gone out of alignment and shifted due to a slightly loose lag screw.
Maybe someone bumped into it recently.
The door runs are housed in a garage door track one on each side of the garage door.
The rollers that your door runs on are guided by two tracks which run from floor to ceiling and continue horizontally parallel to the garage ceiling.
The overhead track should be the same distance away from the door as the wall.
My garage door is shifting to one side when open.
The span from rail to rail is about 1 2 3 4 off but i guess that should be okay.
Adjust the brackets on both sides of the door until you have a consistent garage door track margins.
Measured 15 and the back measured 16 from the wall.
The overhead portion of the garage door track only has one adjustment point.
The cable is attached to the door and runs to an s hook that attaches to the track support.
Adjusting the overhead track.
Or it could just be that the hardware has become loose over time.
Check that it is straight.