But it still shakes.
Garage door shimmies closing.
The first part of the closing is relatively smooth but as the door gets to about half way down on the guide rail.
All these situations will cause the sensors to tell the garage door opener not to close there could be an obstruction.
So i finally got some wd 40 and sprayed the track.
Most companies use a press fit pulley which is made up of two separate pieces attached by ball bearings onto the.
Once you ve determined the proper length of tube to block the sun from the electric eye you may want to go to a hardware store and invest in some plastic or rubber tubing that would be more.
Check the safety sensors.
I have a single car garage door driven by a craftsman belt drive.
If it isn t it could get in the way of the electronic beam and prevent the garage door from closing because the cardboard tube is breaking the beam.
Get shopping advice from experts friends and the community.
There are two types of pulleys.
Press fit pulleys and cast iron pulleys.
Jedi for months i noticed that my garage door shakes when it closes.
My garage door opener starts to close then goes backs up.
If you garage door is lowering then reversing back to the open position there could.
The motor and drive seem to work fine but when i want to close the garage door there is a lot of noise and the door seems to move down in jerks and starts.